What bra to wear with a backless dress depends on how far down the back opening goes. If it stops a few inches below a normal band, a low-back bra or a converter strap hides. If it reaches the waist, use a converter that wraps the waist or a plunge bra with a low-back setting. If it drops below the waist, or the sides are open too, only adhesive cups or cups sewn into the dress will stay out of sight.
That is the whole decision in one paragraph. The rest is about reading the dress correctly, because "backless" covers everything from a scoop between the shoulder blades to a gown open to the base of the spine.
Reading the back of a backless dress
The 1930s made the bare back an evening convention. The Metropolitan Museum's essay on a beaded silk evening dress of about 1932 names the bias cut, low backs and deep V-necks as the defining lines of the period, and the museum holds a 1930 Valentina ensemble with a bare draped back. Ninety years on, designers still cut the back in a handful of recognizable shapes, and each asks for something different underneath.
Measure two things with the dress on: the lowest point of the opening, and whether the sides under the arms are covered. Then match the shape.
| Back of the dress | What hides under it |
|---|---|
| Scoop or V ending above the bra band's usual line | Your normal bra, or a convertible with straps crossed |
| Opening 2 to 4 inches (5 to 10 cm) below the usual band | Low-back bra with angled wings, or a converter strap |
| Open to the natural waist, sides covered | Converter strap fastened at the front, or plunge bra with a low-back band |
| Open below the waist, or open sides | Adhesive cups, adhesive bodysuit, or sewn-in cups |
| Cowl or loose draped back | Adhesive cups or a backless bodysuit; any band shows when the drape swings |
| High neck with a keyhole or open back | Clear-back bra or adhesive cups |
Converter straps: the cheap fix for a bra you already own
A converter is a length of elastic with hook-and-eye pads at the ends. It hooks onto the back closure of an ordinary bra, wraps round the waist and fastens at the front, and its tension drags the band down out of sight. The Canadian retailer Simons describes its version as working with one- or two-hook bras, with pads sized for 5/8-inch (16 mm) hooks. Braza sells a one-size converter for bras from 32A to 40DD.
The tension is the trick and also the limit. A guide on Extra Petite, which shows how to make one from an old bra's hooks and a strip of elastic, says the strap must be taut enough to pull the band down "but not so tight that you're uncomfortable," and that it "will not work on completely back-less items." Loosen the shoulder straps a little before you fasten it, since the cups are now being pulled down and back rather than straight back.
The best base bra for a converter is a molded plunge bra: its low center gore and angled wings already sit close to the body, so the cups are less likely to tip forward when the band drops.
Plunge bras with a low-back setting
Several makers build the converter in. Maidenform has sold a convertible plunge set that ships with a low-back converter strap alongside its halter and crossover straps. Mey's bi-stretch multiway "Deep Plunge" comes with a separately insertable belly band that the German brand says "fits perfectly under dresses with a low back." Curvy Kate's SuperPlunge Multiway, a full-bust design, includes an attachable low-back converter. For a closer look at how these bras are cut, see our guide to the backless bra.
Full busts need more from these bras, not less. Triumph's plunge guide says that "for D cup and above, the key is structured side panels, reinforced underwire, and slightly wider straps." A low band takes leverage away, so those side panels matter more under a backless dress than under a T-shirt.
When there is no band to hide
Below the waist, the choice narrows to products that never go round the body. Adhesive bras are the obvious one; Bragel International launched the NuBra in 2002 as a strapless, backless bra held by a regenerating adhesive. Fashion Forms' Go Bare style is a hybrid: underwired cups with adhesive only on the side wings. Adhesive bodysuits, such as Fashion Forms' U-Plunge bodysuit, combine a brief with stick-on cups and wings, which helps under clingy fabric where a separate pair of knickers would draw a line.
Retailers' instructions for these products are consistent: clean, dry skin with no lotion, a skin test before the event, and a time limit. One stick-on bra listing on ASOS advises a skin test 24 hours before first wear and no more than 4 to 6 hours at a stretch. Our comparison of the backless bra vs adhesive bra covers the trade between support and invisibility.
Cups built into the dress
For a gown you will wear for a whole wedding, the most reliable answer is often to have bra cups sewn in. A seamstress tacks molded cups to the lining or seam allowance, never through the outer fabric, and takes in the side seams so the bodice grips the ribcage and does the work a band would. It suits dresses with a lined, fitted bodice. It does not suit slip dresses, single-layer jersey, or very heavy busts in a dress with no structure, and some dressmakers will say so and refuse the job.
Small details that give the game away
Test the outfit in daylight; Triumph's backless-dress guide points out that natural light shows seams and adhesive edges that indoor light hides. Raise your arms, turn, and sit down in front of a mirror, because a deep armhole reveals a side wing that the back view hid. Choose a bra close to your own skin tone, not white, under pale fabric. And for high-necked dresses with an open back, a clear-back bra, such as the dancewear maker Capezio's clear-back style, trades the band for a transparent strap that reads as nothing at a distance and as plastic up close. Under a cowl that swings, nothing with a band survives the first dance.
Last updated
Questions
Can you wear a normal bra with a backless dress?
Only if the back opening ends above the line where your bra band sits. If it dips lower, add a converter strap that hooks onto the bra's back closure and wraps the waist, which pulls the band down out of sight. Below the waist, a banded bra will show.
Do stick-on bras work for big busts?
They work less well as cup size rises, because the adhesive carries all the weight with nothing under or around the breast. Some lines run to DD or larger, but heat and sweat shorten the hold. For a fuller bust under a low back, a low-back plunge bra with firm side panels, or cups sewn into the dress, usually holds better.
How long can you wear an adhesive bra?
Follow the maker's limit. One stick-on bra sold on ASOS carries a limit of 4 to 6 hours at a time and a skin test 24 hours before the first wear. Apply it to clean, dry skin with no lotion or powder, never sleep in it, and stop and rinse the skin with water if it starts to itch or redden.
What do you wear under a backless wedding dress?
Most brides with an open back either have cups sewn into the bodice, which a seamstress tacks to the lining during alterations, or wear adhesive cups. A low-back plunge bra works if the back stops at the waist. Bring the underwear to every fitting so the dress is altered around what you will actually wear.
Sources
- extrapetite.com: diy how to make bra strap converter for
- ai.simons.ca: backless bra converter 10538 4001
- mey.com: bra on night out
- uk.triumph.com: plunge bra guide
- bustle.com: what bra should i wear with a backless dress 10 options that look g...
- bragel.com: aboutus
- metmuseum.org: 83258
- metmuseum.org: 156049
- brazabra.com: the low down low back bra converter
- kohls.com: maidenform bra sexy convertible plunge bra k2303 womens.jsp
- debras.com.au: curvy kate superplunge multiway bra latte
- dillards.com: 514696314
Discussion
Loading...
